Table of Contents
Advertisement
®
SuperStack
24-Port (3C16465C) User Guide
DUA1646-4AAA05
I
NTRODUCTION
®
The SuperStack
3 Baseline 10/100 Switch is a versatile,
easy-to-use unmanaged switch. It is ideal for users who want the
high-speed performance of 10/100 switching but do not need
sophisticated management capabilities. The Baseline 10/100
Switch is shipped ready for use. No configuration is necessary.
The Baseline 10/100 Switch has 12 or 24 shielded RJ-45, 10/100
Mbps auto-negotiating ports on the front panel. Each port
automatically determines the speed and duplex mode of the
connected equipment and provides a suitable switched
connection. Each port also provides Auto MDIX.
The Baseline 10/100 Switch is suited for office use where it can
be free standing, or rack mounted (in a wiring closet or
equipment room).
The Baseline 10/100 Switch comes with:
One power cord for use with the Baseline 10/100 Switch
!
Four self-adhesive rubber pads
!
One mounting kit
!
The Switch can be powered either from the AC mains supply, or
through an optional 3Com SuperStack 3 Advanced Redundant
Power System (3C16071B). Contact your supplier for details.
The Baseline 10/100 Switch provides high performance switched
connections to 10 Mbps and 100 Mbps hubs, servers and
workstations that require a dedicated switched link.
3 Baseline 10/100 Switch 12-Port (3C16464C) and
B a s e
li n e
1 0 / 1
0 0 S
w it c
h
3 C 1
S u p
6 4 6
e r S t
5 C
a c k
®
3
The diagram below shows an example configuration:
1
Advertisement
Table of Contents
Related Manuals for 3Com SuperStack 3 3C16464C
Summary of Contents for 3Com SuperStack 3 3C16464C
- Page 1 Four self-adhesive rubber pads One mounting kit The Switch can be powered either from the AC mains supply, or through an optional 3Com SuperStack 3 Advanced Redundant Power System (3C16071B). Contact your supplier for details. The Baseline 10/100 Switch provides high performance switched connections to 10 Mbps and 100 Mbps hubs, servers and workstations that require a dedicated switched link.
-
Page 2: Front Panel
(even if the device is operating in full duplex mode). In such a configuration, you may notice some degradation of network performance. 3Com recommends that you use devices that are capable of auto-negotiation (and that you ensure that auto-negotiation is enabled, if it is a configurable option). -
Page 3: Rear Panel Connections
Water or moisture cannot enter the case of the unit. Air flow around the unit and through the vents in the side of the case is not restricted (3Com recommends that you provide a minimum of 25 mm (1 in.) clearance). -
Page 4: Safety Information
AFETY NFORMATION Please read the following safety information carefully before installing the Baseline 10/100 Switch. WARNING: Installation and removal of the unit must be carried out by qualified personnel only. If installing the Switch unit in a stack with SuperStack 3 Hub units, the Baseline 10/100 Switch unit must be installed below the narrower Hub units. -
Page 5: Rack Mounting The Units
OUNTING Introduction The Baseline 10/100 Switch is supplied with two mounting brackets and four screws. These are used for rack mounting the unit. When mounting the unit, you should take note of the guidelines given in “Positioning the Baseline 10/100 Switch” page Rack Mounting the Units The Baseline 10/100 Switch is 1U high and will fit a standard... -
Page 6: Fcc Statement
UPPORT The following options are available for technical support: In the first instance contact your Network Supplier. Check the 3Com knowledgebase at http://knowledgebase.3com.com Browse the 3Com web site on http://www.3com.com Country Telephone Number Asia, Pacific Rim Australia 1 800 678 515... -
Page 7: Product Registration
Improving our environmental record on a continual basis Product Registration You can now register your SuperStack 3 Baseline 10/100/1000 Switch on the 3Com web site: http://support.3com.com/registration/frontpg.pl Documentation Feedback Your suggestions are very important to us. They will help make our documentation more useful to you. Please e-mail comments about this document to 3Com at: pddtechpubs_comments@3Com.com...