Schaefer TW30W Operator's Manual

Schaefer TW30W Operator's Manual

Oscillating circulation fan

Advertisement

Quick Links

IMPORTANT: READ AND SAVE THESE INSTRUCTIONS

Read all instructions carefully before attempting to assemble, install, operate or service the product described.
Failure to comply with instructions could result in personal injury and/or property damage.
Using this product for any other purpose than it was intended, or not within the operating specifications in this
manual will void the warranty and may cause damage to the fan or serious injury to personnel.
!
WARNING - TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK:
• Do not expose fan to water or rain.
• Do not use this fan with any speed control device.
• The power source must conform to the electrical requirements of the fan.
• The power cord has a 3-prong grounded plug that must be plugged into a GFCI (Ground Fault Circuit Interrupter) protected
circuit.
• Do not alter the plug to remove the grounding prong and never use a 2-prong adapter.
• Replace damaged or worn power cords immediately.
• Where possible, avoid using extension cords. If one must be used, the cord must be UL listed, be the proper size (Amp
rating), and have 3-prong grounded connections.
GENERAL SAFETY INFORMATION:
• Before operating this fan, check for worn, damaged, or missing parts and replace or repair as needed.
• To avoid risk of fire, electric shock or personal injury, disconnect from power source before servicing.
• This fan is intended for general use only. Do not use near hazardous or explosive materials or vapors.
• Never insert fingers or any other objects through the guards when fan is in operation.
• Never operate fan without guards in place.
• Unplug the fan before moving from one location to another.
• All Warning and Caution labels must be kept in good condition and be replaced if not clearly readable.
• Carefully read all safety messages in this manual and on your equipment safety labels. Follow recommended precautions
and safe operating practices.
WARNING! CALIFORNIA PROPOSITION 65:
including lead, which are known to the State of California to cause cancer and birth defects or other
reproductive harm. For more information go to www.P65Warnings.ca.gov.
Oscillating Circulation
Fan Operators Manual
This product can expose you to chemicals,
Sauk Rapids, MN 56379 USA • www.schaeferventilation.com
1
1
© 2019 Pinnacle Climate Technologies, Inc.
SCVD-403

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TW30W and is the answer not in the manual?

Questions and answers

Summary of Contents for Schaefer TW30W

  • Page 1 Oscillating Circulation Fan Operators Manual IMPORTANT: READ AND SAVE THESE INSTRUCTIONS Read all instructions carefully before attempting to assemble, install, operate or service the product described. Failure to comply with instructions could result in personal injury and/or property damage. Using this product for any other purpose than it was intended, or not within the operating specifications in this manual will void the warranty and may cause damage to the fan or serious injury to personnel.
  • Page 2 • Contact your shipper immediately if any damage is found. INSTALLING YOUR FAN Schaefer offers a variety of wall mounts and pedestal mounts for installing your fan. Fan mount must be installed on a support structure strong enough for the added weight of the mount and fan assembly. The customer is responsible for determining that their structure is adequate to support these loads.
  • Page 3 INSTALLING THE FAN TO A PEDESTAL ASSEMBLY Use the supplied hardware that came with your fan to attach the fan. 1. Position the fan assembly with the Oscillator Base at either side of the mounting tab. 2. Install the 3/8" bolt through the center hole of the Oscillator Base and fasten with 3/8"...
  • Page 4 Long leg out, Short leg out, short leg down long leg down MOUNTING CONFIGURATIONS Schaefer’s wall mount bracket can be assembled in two configurations. Some configurations will limit the fan angle adjustment range. WALL BRACKET ASSEMBLY Kit Contents: Formed Bracket, Diagonal Brace, Swivel Tab (2) 1/4"-20 x 3/4"...
  • Page 5 THE HARDWARE TO ATTACH YOUR FAN TO THE FAN MOUNT BRACKET IS NOT SUPPLIED IN THIS KIT. Note: Fasteners are supplied with all current Schaefer circulation fans. Note: Stainless steel fasteners should be coated with a lubricant (WD-40) to prevent thread galling and allow subsequent adjustment.
  • Page 6 TROUBLESHOOTING SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION 1. Fan not plugged in 1. Check power cord connection 2. Blown fuse or tripped circuit breaker 2. Replace fuse or reset circuit breaker Fan does not operate 3. Defective on/off switch 3. Repair or replace switch  ...

Table of Contents