Removing An Sfp Transceiver - 3Com OfficeConnect 3CR16708-91 Getting Started Manual

5 The 1000BASE-SX or 1000BASE-LX fiber transceiver connects to the
6 Connect the other end of the cable to a device fitted with an appropriate
7 Check the Module Status LED on the front of the Switch to ensure that it
Removing an SFP
Transceiver
1 Disconnect the cable from the transceiver.
2 Move the wire release lever downwards until it is pointing toward you.
3 Pull the wire release lever toward you to release the catch mechanism;
Figure 6 Inserting a SFP Transceiver
1 2 V
D C
3 . 5 A
M A X
Product
label
Wire release
lever
network using a duplex LC connector. The 1000BASE-TX transceiver
connects to the network using an RJ-45 connector. If you are using a fiber
transceiver, attach a male duplex LC connector on the network cable into
the duplex LC connector on the transceiver. If using a 1000BASE-TX
transceiver, attach an RJ-45 connector on the network cable into the
RJ-45 connector on the transceiver.
Gigabit Ethernet connection.
is operating correctly. Refer to "LEDs" on page 14 for more information.
If you wish to remove a 3Com transceiver (it is not necessary to
power-down your Switch):
the transceiver will then easily slide out.
SFP Operation 31
Suitable slot
o n Switch 9 FX