3Com IntelliJack NJ200 User Manual page 50

Troubleshooting the NJ200
Event/Message
Green LEDs on Ports 1-4
are not on
Amber LED on Port 1 is
not lit
Authentication Failure
Timeout
Attributes Error
General Error
46
Description
Network device has no
connection to Network Jack
ower is not being
P
forwarded to network
device
Wrong password has been
entered
Device did not respond
within a specified period of
time
Unexpected configuration
parameters
Something other than
authentication failure,
timeout or attributes error
has occurred
Solution
Make sure the cable is properly
connected to the network device. Make
sure the cable is firmly connected to one
of the four Network Jack ports labeled 1-
4. Make sure the cable is a good straight-
through cable.
Make sure the cable is properly
connected to the network device. Make
sure the cable is firmly connected to one
of the four Network Jack ports labeled 1-
4. Make sure the cable is a good straight-
through cable. Make sure network
device is 802.3af compatible. Make sure
the power requirement for network
device does not exceed 7 watts.
Confirm correct password and re-type.
Refresh the screen after a few seconds. If
the problem persists, try to rediscover the
device.
Confirm that you have specified valid
parameter values and retry the
configuration operation.
NOTE: This error should not appear to the
user under normal conditions.
Retry the operation you were performing.
NOTE: This error should not appear to the
user under normal conditions.