Advertisement
Find Quality Products Online at:
2.
Reduce amounts of material processed to less than
the full 4-liter capacity when working with viscous or
fibrous materials.
3.
When cleaning exterior of container, keep it in normal,
upright operating position to prevent liquids from
running into the bearing through the bottom end.
HOT BLENDING INSTRUCTIONS: IMPORTANT!
To minimize the possibility of scalding when blending hot
materials, the following precautions and procedures must be
observed:
• Hot materials are those which are 100˚F (38˚C) or hotter.
• Always start blending on lowest speed setting, then
progress to desired speed.
• Never stand directly over blender when it is being started
or while it is running.
• Constant monitoring of the condition of the container lid
gasket and the container lid clamps is mandatory. Replace
these parts if they become worn or loose, or are damaged
in any way.
MAINTENANCE
Motor – Not for water-jet cleaning.
The Waring Commercial Blender ball-bearing motor requires
no greasing or oiling. Sealed-in lubrication provides smooth
unit operation.
Container – The stainless steel container can be sterilized
without injury to the bearing.
Container pad is to be washed and rinsed in solutions as
noted in the separate Cleaning and Sanitizing Instructions.
Depending on the operating conditions, service life of the
main components of the container blade assembly, socket
head shaft and shaft seals is 500 hours of actual running time.
GlobalTestSupply
www.
9
.com
sales@GlobalTestSupply.com
Advertisement
