Table of Contents
Advertisement
QUICK START GUIDE EL-IPD-PRE-MSI
INSTALLATION
If mounting the EL-IPD-PRE-MSI Multi Zone Audio Matrix in a cabinet, place it on a sturdy shelf. Ensure clear positive
airflow within the cabinet by using fans. Locating the EL-IPD-PRE-MSI in a completely enclosed cabinet is not
recommended due to heat build up.
Use the included rack mount ears and hardware to mount into a standard equipment rack. Use only the included
screws to attach the ears to the EL-IPD-PRE-MSI. Ensure adequate ventilation for the EL-IPD-PRE-MSI by leaving
at least one blank rack space empty above and below. If the rack is completely closed, use positive ventilation to
dissipate heat build up.
ADDING THE NETWORK AUDIO CARD
THUMBSCREWS
If you are linking other ELAN Dante
enabled
TM
devices with the EL-IPD-PRE-MSI Multi Zone
PreampAudio Matrix, you will
need to add the
EL-IPD-NAC-EXT Dante
TM
Network Audio Card. Loosen
and
the two thumbscrews on the standard LAN card
remove the card. Slide the EL-IPD-NAC-EXT Dante
TM
Network Audio Card into the rails on the chassis,
press firmly and tighten the two thumbscrews.
TRIGGER OUTPUT CONNECTIONS
There are 3 trigger outputs available on the
EL-IPD-PRE-MSI Multi Zone Preamp Audio Matrix.
The trigger outputs can be configured using the event
mapper. For more information see the integration note.
Use 3.5mm mono interconnect cables to connect the
EL-IPD-PRE-MSI Multi Zone Preamp Audio Matrix trigger
3.5mm Mono Interconnect Cable
outputs to the device that needs to be turned on.
Pinout
Signal
Ground
10
www.elanhomesystems.com
Advertisement
Table of Contents
