Damping (Damping) - ABB 266HSH Instruction Manual

Menu
Communication
Exit Select
Communication
Protocol Settings
Protocol
HART Address
Back
Communication
Protocol Settings
Protocol
HART Address
Back
Communication
Protocol Settings
Protocol
HART Address
Back
7.13

7.11 Damping (DAMPING)

Pressure transmitter output signals that are noisy as a
result of the process can be smoothed (damped)
electrically.
The additional time constant can be set between 0 s and
60 s in increments of 0.0001 s. Damping does not affect
the value shown on the digital display as a physical unit. It
only affects the parameters derived from this, such as the
analog output current, free process variable, input signal
for the controller, and so on.
The damping adjustment can be performed in different
ways:
— Via the the local HMI:
Enter the menu: > Device Setup > Output Scaling
> Damping.
Set the damping to the desired value.
— Via the Asset Vision Basic Software:
See Asset Vision Software Operating Instructions.
— Via the Hand Held Terminal:
See relevant operating instruction
2 6 6 H S H M O D B U S T R A N S M I T T E R | P R E S S U R E / T E M P E R AT U R E M U LT I VA R I A B L E | O I/ 2 6 6 H S H M T- E N R E V. A
9
Communication
- Protocol Settings
- Protocol
- HART Address
1 Communication
Protocol Settings
Software
Select Back
1 Communication
Protocol
Select Back
1 Communication
HART Address
Select Back
1
1
Communication
Operate/Modbus
Back
1
HART Address
Max 15
0
Min 0
Next
Edit
1
Select
OK
33