Setup
Important: Remove and discard the protective plastic
sheet that covers the engine and any other plastic or
wrapping on the machine.
1
Installing the Blade-Control
Bar
No Parts Required
Procedure
Install the blade-control bar into the upper handle
2
Assembling and Unfolding the
Handle
No Parts Required
Procedure
1. Remove and save the 2 handle knobs and 2 carriage
bolts from the handle brackets
(Figure
Figure 3
(Figure
4).
1. Handle knob (2)
3).
2. Install the handle ends onto the mower housing so that
the pin attached to each handle bracket is in the lower
hole of its related handle end
1. Pin
Note: The pins do not show through the holes in the
handle ends when the handle is in the folded position.
3. Unfold the handle to the operating position by rotating
it rearward
(Figure
4
Figure 4
2. Carriage bolt (2)
(Figure
5).
Figure 5
2. Handle end
6).