Connecting Cables To Terminals - Kenwood KRC-478R<u>/RV</u> Instruction Manual

Connecting Cables to Terminals

ISO connector unsupported car (KRC-478R/378R/33R only)
2CAUTION
When only two speakers are being connected to
the system, connect the connectors either to both
the front output terminals or to both the rear
output terminals (do not mix front and rear). For
example, if you connect the + connector of the
left speaker to a front output terminal, do not
connect the - connector to a rear output
terminal.
2WARNING
If you connect the ignition cable (red) and the
battery cable (yellow) to the car chassis (ground),
you may cause a short circuit, that in turn may
start a fire. Always connect those cables to the
power source running through the fuse box.
If no connections are made, do not cut the tube off from
the edge of the cable.
Connect either to the power control terminal
when using the optional power amplifier, or
to the antenna control terminal in the vehicle.
Ignition key
switch
Car fuse box
(Main fuse)
+ –
Battery
Rear left output (White)
Rear right output (Red)
FM/AM
antenna input
Antenna Cord (ISO)
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
Power control/ Motor antenna
control cable (Blue/White)
P.CONT.OUT
ANT.
CONT.
ACC
Car fuse box
Ground cable (Black) - (To car chassis)
Power Control terminal
(P.28)
TEL mute terminal
Wiring harness
(Accessory1)
Ignition cable (Red)
Battery cable (Yellow)
— 27 —
Front right output (Red)
(KRC-478R/478RV only)
Front left output (White)
(KRC-478R/478RV only)
Fuse (10A)
Plug (P.29)
KENWOOD disc changer
/ DAB control input
NOTE
To connect the Disc changer or
DAB unit, consult each manual.
NOTE
To connect the KENWOOD
navigation system, consult
your navigation manual.
White/Black
To front left
speaker
+
FRONT • L
White
Gray/Black
To front right
speaker
+
FRONT • R
Gray
Green/Black
To rear left
speaker
REAR • L +
Green
Purple/Black
To rear right
speaker
REAR • R +
Purple