Kenwood KRC-478R<u>/RV</u> Instruction Manual page 28

Connecting Cables to Terminals
ISO connector supported car
For Volkswagen car
Special antenna cable
(Commercially available)
To Power Control terminal
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
Rear left output
(White)
Power Control terminal
(P.28)
Antenna
Cord (ISO)
Antenna Conversion
Adaptor (ISO–JASO)
(Accessory3)
Car's wiring
FM/AM
harness
antenna input
Rear right
output (Red)
Front right output (Red)
(KRC-478R/478RV only)
Front left output (White)
(KRC-478R/478RV only)
Fuse (10A)
Plug (P.29)
KENWOOD disc changer
/ DAB control input
NOTE
To connect the Disc changer
or DAB unit, consult each
manual.
TEL mute terminal
NOTE
To connect the KENWOOD
navigation system, consult
your navigation manual.
— 28 —
Power Control Terminal Connections
The output of the Power Control terminal is switched along
with the power on/off switching of the unit.
This terminal can be connected to the P.CON (REMOTE)
terminal of the amplifier, or used as the power supply of the
special antenna cable for Volkswagen cars. (MAX. 400 mA)
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
Antenna Cord (ISO)
Special antenna cable
(For Volkswagen car)
(Commercially available)
Power Control terminal
(Flat terminal)
Power control cable
Power Amplifier