Advertisement
display button once changes the display to its "dim" or "low intensity" setting, pressing
the button a second time selects "off" for the display. When "off" is selected any
other control function will cause the display to indicate product operational status
for approximately 7 seconds and then the display will once again blank. Pressing the
display button a third time cycles back to a "bright display"
Ext amp on: is not used with the INT-25. This is used on other Pass preamps and has no
effect on this product.
This remote is designed to operate several pieces of Pass Labs
electronics, not all of the functions available on this remote will
be applicable to your Pass Laboratories INT-25.
Power: Pressing power alternates between standby and on.
Mute: Pressing mute once will quiet the pre-amplifi er outputs;
pressing mute a second time will return you to the previous
volume control setting
Input Selection: Pressing. 1,2,3 will immediately move the input
selection to that input selection; volume and balance settings will
not be disturbed.
Volume: Pressing the increase (^) button or the decrease (v)
button will shift the volume setting 1dB, holding a button down
will increase or decrease the level until such time as you either
release pressure on the button or reach the limits of the volume
control.
Balance: is not used with the INT-25. This is used on other Pass
preamps and has no effect on this product.
Tape
is not used with the INT-25. This is used on other Pass
:
preamps and has no effect on this product.
Pass Thru: is not used with the INT-25. This is used on other Pass
preamps and has no effect on this product.
Display: The default setting for the display is "bright", pressing the
6
Advertisement
