Advertisement
Quick Links
Advertisement
Related Manuals for Pass Laboratories INT-150
Summary of Contents for Pass Laboratories INT-150
- Page 1 INT-150 Owner’s Manual Nov 19, 2007 INT-150 Owners Manual...
- Page 2 Excessive heat can shorten the life of the product and may cause the electronics to self protect and shut down. Never block any ventilation openings. Allow at least 6 inches of clearance around these products for proper ventilation. INT-150 Owners Manual...
- Page 3 (530) 367 3690 fax: (530) 367 2193 “Pass”, “pass”, “Pass Labs”, “Pass Laboratories”, Supersymmetery”, “Aleph”, and “Zen” and are all registered trademarks of Pass Laboratories, Inc., and all rights thereto are protected by law. INT-150 Owners Manual...
- Page 4 Class A power amplifiers and later, high power amplifiers using only local feedback (the Stasis series). Pass sold Threshold and created Pass Laboratories in 1991, where he concentrated first on elevating single-ended Class A power amplifiers to new power levels and performance, the Aleph series.
- Page 5 (in approximately that order). That is why we make more than one amplifier, but all are built with the same commitment to quality. The Pass Laboratories INT-150 Integrated Amplifier was designed specifically to bridge the gap between so called high-end audiophile product and the need for a simple “no nonsense”, convenient, user-friendly, high...
- Page 6 Should your audio system have a device that requires an additional signal ground you will find that ground on the rear of the INT-150 at the white binding post which is marked “Signal Gnd”.
- Page 7 Pre-amplifier inputs (1&2 XLR/RCA , 3&4 RCA) Pre-amplifier outputs (XLR OR RCA) Right Channel speaker connector Signal ground connector IEC 520 AC power inlet module Main Power switch (not a safety disconnect) Fuse holder Left Channel Speaker connector INT-150 Owners Manual...
- Page 8 The amplifier’s voltage and current rating are indicated on the rear panel. It will be indicated as either 100 volts, 120 volts, 220 volts, 230 volts or 240 volts. The smaller Pass Laboratories power amplifiers, preamps and integrated amplifiers use a slow-blow 3AG (equivalent to 313 in EC markets) type fuse.
- Page 9 On the XLR connector pin 1 is ground, pin two is positive input and pin 3 is inverted (negative) input. Pin numbers are marked on the XLR. If you re-install the jumper incorrectly or leave it lying about, the amplifier will not work properly, and you will be able to tell. INT-150 Owners Manual...
- Page 10 Input 5, tape loop, pass through and external amp on are not applicable to the INT-150, integrated amplifier. The hand remote has two (2) AAA batteries that can be replaced after the back cover from the remote has been removed.
-
Page 11: Speaker Interface
We have found that about 90 per cent of bad sounding cables are really bad sounding connections, and we recommend that attention be paid to cleanliness of electrical contact surfaces and proper connector fit. INT-150 Owners Manual... -
Page 12: Product Life
<300 uV unweighted 20-20 kHz Dynamic range: 140 dB Balanced CMRR: < -50 dB @ 1 KHz DC offset: < 50 mv Power Consumption: 225 watts idle, 600 watts maximum Dimensions: 19W x 7H x 19D Weight: 60 lbs. approx . INT-150 Owners Manual... -
Page 13: Warranty Information
Product with altered or missing serial numbers will be suspected as counterfeit product. Pass Laboratories will not repair or in any way indemnify any counterfeit or cloned product. Pass Laboratories does not offer products in voltages intended for inter- national markets either to authorized Pass Labs dealers or to third parties located in the United States or Canada.