Installation - Kenwood KDC-M6024/G Instruction Manual

Installation

Installation
Firewall or metal support
Screw (M4X8)
(commercially
available)
Metal mounting
Self-tapping
strap
screw
(commercially
(commercially
available)
available)
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (eg, the sound may skip).
Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it
does not fall off.
1
Refer to the section <Removing the hard rubber frame> (page
34) and then remove the hard rubber frame.
2
Drop open the faceplate by pressing the Release button.
3
Tighten the screws (ø2.6 × 12 mm) (Accessory
shown on the diagram.
Bend the tabs of the
4
Tighten the screws (ø2 × 4 mm) (Accessory
mounting sleeve
shown on the diagram.
with a screwdriver or
similar utensil and
attach it in place.
5
Tighten the screws (ø2 × 6 mm) (Accessory
shown on the diagram.
Never insert the screws in any other screw hole than the one specified.
If you screw them in another hole, it will contact and may cause
damage to the mechanical parts inside the unit.
— 33 —
4 ) in the holes
Accessory4
) in the holes
5
Accessory5
6 ) in the holes
Accessory6