Chevrolet Spark 2021 Owner's Manual page 11

10 Keys, Doors, and Windows
The security light will turn off once the
key has been programmed.
6. Repeat Steps 1 5 if additional keys are to
be programmed.
If a key is lost or damaged, see your dealer
to have a new key made.
Programming without a Recognized Key
Program a new key to the vehicle when a
recognized key is not available. Canadian
regulations require that owners see their
dealer.
If two currently recognized keys are not
available, follow this procedure to program
the first key.
This procedure will take approximately
30 minutes to complete for the first key.
The vehicle must be off and all of the keys
you wish to program must be with you.
1. Insert the new vehicle key into the
ignition.
2. Turn the ignition on without starting the
vehicle. The security light will come on.
3. Wait 10 minutes until the security light
turns off.
4. Turn the ignition off.
5. Repeat Steps 2 4 two more times. After
the third time, turn the ignition on
without starting the vehicle; the key is
learned and all previously known keys
will no longer work with the vehicle.
6. To program the second key, turn the
ignition off and insert the second key to
be learned and turn the ignition on
without starting the vehicle.
After the two keys are learned, remaining
keys can be learned by following the
procedure in Programming with Two
Recognized Keys.
Battery Replacement (1LT Only)
Caution
When replacing the battery, do not touch
any of the circuitry on the transmitter.
Static from your body could damage the
transmitter.
The battery is not rechargeable. To replace
the battery:
1. Press the button on the side of the RKE
transmitter to extend the key. Never pull
the key out without pressing the button.
2. Remove the battery cover by prying it
with a finger.
3. Remove the battery by pushing on the
battery and sliding it toward the key
blade.
4. Insert the new battery, positive side
facing up. Push the battery down until it
is held in place. Replace with a CR2032 or
equivalent battery.
5. Snap the battery cover back on to the
transmitter.