2 Legal Notices; 2.1 Ce Notice; 2.2 Fcc Notice; 2.3 Licence Conditions - pico Technology HumidiProbe Quick Start Manual

2 HumidiProbe User's Guide
Legal notices
2
2.1 CE notice
The HumidiProbe meets the intent of EMC directive 89/336/EEC and meets the EN61326-1 (1997)
Class A Emissions and Immunity standard.
The HumidiProbe also meets the intent of the Low Voltage Directive and meets the BS EN
61010-1:2001 IEC 61010-1:2001 (safety requirements for electrical equipment, control, and
laboratory use) standard.
2.2 FCC notice
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules . These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his or her own expense.
For safety and maintenance information see the
2.3 Licence conditions
The material contained in this release is licensed, not sold. Pico Technology Limited grants a
licence to the person who installs this software, subject to the conditions listed below.
Access
The licensee agrees to allow access to this software only to persons who have been informed of
these conditions and agree to abide by them.
Usage
The software in this release is for use only with Pico products or with data collected using Pico
products.
Copyright
Pico Technology Limited claims the copyright of, and retains the rights to, all material (software,
documents etc.) contained in this release. You may copy and distribute the entire release in its
original state, but must not copy individual items within the release other than for backup purposes.
Liability
Pico Technology and its agents shall not be liable for any loss, damage or injury, howsoever
caused, related to the use of Pico Technology equipment or software, unless excluded by statute.
Fitness for purpose
Because no two applications are the same, Pico Technology cannot guarantee that its equipment
or software is suitable for a given application. It is your responsibility, therefore, to ensure that the
product is suitable for your application.
Mission-critical applications
This software is intended for use on a computer that may be running other software products. For
this reason, one of the conditions of the licence is that it excludes usage in mission-critical
applications, for example life support systems.
HumidiProbe044-3
safety warning.
Copyright © 2005-2007 Pico Technology Limited. All rights reserved.