Using The Menus; Setup Using The Setting Display - Toshiba TDP-T420U Owner's Manual

Using handy features (Continued)
How to set password (from [Off] to [On])
Select [Password] in the Default setting 2 menu and press the
1
button.
Select [Password setting] next, and press the
2
3 Select [On].
4 Select [OK] and press the
The password entry screen is displayed.
5 Enter the password using numeric keys of the remote control.
The password setting will be set as [On].
6
How to operate when password is [On]
Turn on the power.
1
2 The lamp lights and the password entry screen appears.
Enter the password using numeric keys of the remote control.
3
If the entered password is correct, the start-up screen appears and the projector
goes into normal operation. If the password is wrong, a message appears to prompt
you to re-enter the password, and again the password entry screen is displayed. If
you enter a wrong password for more than 5 times, the projector will automatically
power off and enter standby mode.
Note
• When the password setting is [On], the password will be enabled only when the
power is turned on for the first time after the main power switch has been on.
The password function will not be activated if the power backed on while it is
standby mode without turning off the main power switch.
How to set password (from [On] to [Off])
1 Select [Password] in the Default setting 2 menu and press the
button.
The password entry screen is displayed.
2 Enter the password using numeric keys of the remote control.
Select [Password setting] next, and press the
3
Select [OFF].
4
Select [OK] and press the
5
or
or button.
button.
or
or button.
button.
4

Using the menus

You can call up on-screen menus, and conduct a number of adjustments and settings using
the operation buttons on the control panel (main unit side) and remote control.
p.16

Setup using the Setting display


The menu shown below is for operation instructions purposes and might differ from the
actual display.
1. Press the MENU button
Display the Setting display menu.
2. Select a Category
Select a category by using .
There are following 6 categories:
Image adjustment menu p.36
Position adjustment menu p.37
Display setting menu p.38
Default setting 1 menu p.41
Default setting 2 menu p.42
Status display menu p.43
3. Adjustments & Settings
Press
Item
Adjustment/Setting Value
These marks signify
the items can be
adjusted/set by using
.
These marks signify the items can
be selected from the list by using
.
After an item is selected, apply it by
pressing .
• The figure shows displays given for operation instructions purposes. As the display may differ depending on the item,
refer to the following applicable pages for the menu item you desire.
• To return to previous item, press the RETURN button.
4. End Press the MENU button once more.
(The menu will disappear automatically after 30 seconds, if no operation is conducted.)
Displays the current
adjustments and
settings of selected
category.
Item shown with gray
cannot be adjusted with
the current input source.
or to open the menu.
These marks These marks signify
signify that there
that there are setting
are options.
screens. Press
Press or
to display a list of
to display a list of
setting screens.
options.
* When no item is
changed, press
Toggle items with .
Select items with and press .
Fix selection with .
5
or
.