Timer Recording - Toshiba D-VR650KU Owner's Manual

You can program the unit to record up to 12 programs
within a month in advance. Daily or weekly program
recordings are also available.
Before recording, make sure
• Set the clock before setting a timer programming.
• Insert a recordable disc with enough recordable space or
a cassette tape with an erase-protection tab.
OPEN/
CLOSE
.@/: .@/:
GHI GHI
PQRS PQRS
DTV/TV
DISC MENU
CLEAR
REV
SKIP SKIP
PAUSE
DUBBING
REPEAT
Note
• If you have not set the clock yet:
"Manual Clock Setting" menu will appear instead of the timer programming list at step 1. Continue with the step 4
in "Manual Clock Setting" on page 31 before setting a timer programming.
• Use [s / B] to move the cursor to the left and the right in "Timer Programming" menu.
• If a basic recording or one-touch timer recording is in progress on one component (e.g., VCR) and the timer
recording set for the other component (e.g., DVD) is about to begin, the unit automatically switches to the
programmed channel for timer recording 2 minutes before the programmed starting time, and the recording in
progress (for VCR) will be canceled UNLESS their recording channels are the same. If their recording channels are
the same, the timer recording will start without canceling the recording currently in progress. In this case, the
recording of the same channel will be made on both DVD and VCR.
• You cannot make a program whose recording time exceeds 12 hours.
• Cancel the timer-standby mode by pressing [TIMER SET] before operation for either DVD or VCR. When finished
operating, press [TIMER SET] to resume the timer-standby mode.
• In the timer-standby mode, you can turn on the power and use the component (VCR or DVD) which is not
currently timer-programmed.
E9MG0UD_D-VR660KU_EN.indd 49 E9MG0UD_D-VR660KU_EN.indd 49

TIMER RECORDING

INPUT
HDMI
SELECT
ABC ABC DEF DEF
CH
JKL JKL MNO MNO
TUV TUV WXYZ WXYZ
TIMER TIMER
SPACE SPACE
PROG. PROG.
SETUP SETUP DISPLAY AUDIO
TOP MENU
ENTER ENTER
RETURN
INSTANT 1.3x/0.8x
TIME SLIP
SKIP PLAY
PLAY FWD
STOP SKIP SKIP
VCR DVD
REC MODE REC
TIMER SET TIMER SET SEARCH ZOOM
SE-R0294
Guide to Timer Programming Display
3 1
Timer Programming
JAN/ 2/08 12:00 AM 125-01 SP
SP (1:00) TUE JAN/01 10:00AM
Date Start
JAN/02 12:00AM 1:00AM DTV 125- 1
New Program
4
1. Title of a Timer Program (Contains date, time, channel,
recording mode of the program)
2. Current date and time
3. Recording mode and length of the recording
4. Timer program list
5. Total number of pages and current page (2 pages maximum)
1
Press [TIMER PROG.].
Use [K / L] to select "New Program",
2
then press [ENTER].
Timer Programming
TUE JAN/01 10:00AM
Date Start End
New Program
• If there are 6 or more programs, use
[SKIP j / i] to change pages.
Instructions continue on the next page.
2
End CH
1/1
5
CH
1/1
EN 49
2008/01/29 17:20:58 2008/01/29 17:20:58