Toshiba D-VR600 Owner's Manual page 18

Introduction
Connections with the TV or audio component
Connect to a TV with HDMI output
HDMI stands for High Definition Multimedia Interface. HDMI transfers digital audio and uncompressed digital
video on a single cable. As a result, audio cables and video cables don't need to be connected separately to a
device. In addition, HDMI is compatible with HDCP (High Bandwidth Digital Content Protection).
To HDMI OUT
NOTES:
• Refer to the owner's manual for the TV to be connected to this recorder for more information concerning HDMI
connections.
• HDMI is an evolving technology, so it is possible that some devices may not operate properly with this recorder.
• For proper operation, it is recommended that you use as short an HDMI cable as possible. You may not encoun-
ter difficulty if you use an HDMI cable that is shorter than 16.4 ft (5m).
• Defects in picture and sound quality may occur depending on the quality of the HDMI cables and the nature of
the TV set.
• No sound will be output from the HDMI OUT jack if the "Digital Output Mode" is not set to "PCM" (see page 27).
To select the HDMI output resolution
1. Turn ON the TV and set to the HDMI mode.
2. Press RESOLUTION on the remote control to display the present output resolution.
The on-screen display of the output resolution will appear on the upper right of the TV screen
for approx. 10 seconds.
3. While displaying the output resolution on-screen, press RESOLUTION. The output resolution
will change to the next resolution in the following order.
NOTES:
• When the HDMI cable is connected, the HDMI indicator "HDMI" on the display window will light up.
• If the HDMI cable is disconnected, the HDMI indicator "HDMI" on the display window goes off. In this case,
connect the HDMI cable again.
18
2K70101A_E P12-19
HDMI Cable (not supplied)
HDMI
480p (Progressive)
720p (Progressive)
1080i (Interlace)
18
HDMI-compatible
display
To HDMI input
08`02`07, 20:42