Table of Contents
Advertisement
4.
EARLY MODELS
4.01
Tape Lid Mechanism
N ote: Remove top and tape guideplate.
Lubricate before adjustment.
TAPE LID
(1)
To Check
Hold tape against notch in tape guide
plate.
4''
lid with slot in plate. Align tape -out
pin hole in plate tape lid with hole in
plate. C heck clearance between tape
lid and pivot shoulder.
Requirement
clearance between tape lid and pivot
shoulder.
To Adjust
Loosen tape lid mounting nuts friction
tight. Insert tip of TP156743 gauge
through slot and into groove of lid.
Position tape lid bracket. Retighten
nuts.
(Right Side View)
TAPE LID B EARING BRACKET
Align feed wheel groove in tape
M OUNTING SCREWS
To Check
( 2 )
Requirement
To Adjust
(3)
To Check
Requirement
To Adjust
TAPE LID
BRACKET
MOUNTING
NUTS
TAPE LID
LATCH
BAIL
ISS 5, SECTIO N 573-1 2 7 - 703
Tape lid front bearing surface should
rest squarely against tape guideplate,
Check rear bearing surface clearance.
Note:
When both plates are assembled
on unit, left edge of lid may touch top
plate and some change in this clearance
may be expected.
clearance between rear bearing
surface and tape guideplate.
Loosen tape lid bracket mounting
screws friction tight.
Press tape lid
against tape guideplate.
bracket. Recheck requirement.
tighten bracket mounting screws.
Latch tape lid against tape guideplate.
Check release plunger for endplay.
when lid is latched against tape guide
plate.
Loosen eccentric mounting post lock
nut friction tight. Raise tape lid. Ro
tate high part of eccentric toward tape
guideplate. Close lid and rotate ec
centric toward bracket until latch just
falls under flat on post.
depressing plunger. With lid held
down operate plunger. Tip of latch
should clear post.
(Bottom View)
LATCH BAIL
FEED WHEEL
ECCENTRIC
PIVOT
SHOULDER
Position
Re
Recheck by
SLOT
Pag e
55
Advertisement
Table of Contents
