Table of Contents
Advertisement
2.16
Feed Wheel Mechanism
(B)
FEED RATCHET DETENT SPRING
Requirement
With main shaft in stop position
and feed pawl held away from
its ratchet
to start roller moving away from
ratchet.
MAIN BAIL
TRA NSFER LEVER
GUIDE POS T
MAIN BAIL TRIP LEVER
(C)
Requirement
To Adjust
TOP PLATE
MAIN BAIL
ECCENTRI C
FEED WHEEL DETENT
(A)
MAIN BAIL S PRING
Requirement ( Top plate removed)
(Front View)
ISS 5, SECTION 573-127-703
(Replace top plate)
Unit in stop position, clearance between tip
o f highest sensing pin and top s urface of
tape guideplate should be flush to 0. 005
i n c h below.
With clutch disengaged, loosen front and
rear transfer lever guide eccentric post
l ocknuts.
Position highest point of
eccentric post (as indicated b y dot on end
of post) t oward left and rotate post so
tha t its eccentric positi ons trip lever.
Tighten locknuts.
FEED WHEEL
RATCHET
GUIDE
PlATE
ECCENTRIC
Clutch disengaged, unit on its back.
unh o oked from main bail
to pull spring to in stalled length.
TAPE
Spring
19
Page
I
.J
Advertisement
Table of Contents
