Bell 28E Adjustments page 33

2. 32 Basic Gear Adjustments
REAR B EARING
BRACK ET
INTERME DIATE GEAR - TRANSM ITTER
DISTRIB UTOR GEAR BACKLA SH
To Check
With the MOTOR POSITION and TRANS­
MITTER DISTRIBUTOR POSITION adjust­
ments completed, check the backlash be­
tween the gears.
(1} Requirement
Only a perceptible amount of backlash
between the intermediate driving gear
and the transmitter distributor gear.
To Adjust
Loosen three mounting screws that se­
cure the transmitter distributor unit to
its base. Position transmitter distribu­
tor to meet the requirement. Retighten
the mounting screws.
---
-----
, ,
'J
INTERMEDIATE
DRIVING GEAR
DRIVE SHAFT
ISS 5, SECTION 573-127-703
TRANSMITTER
DISTRIBUTOR
GEAR
(Left Side View)
INTERMEDIATE
S HAFT
ASSEMBLY
TRANSMITTER DISTRIBUTOR GEAR
TRANSMITTER- DISTRIBUTOR
MOUNTING SCREWS
(2) Requirement
Only a perceptible amount of backlash
between the drive gear and the trans­
mitter distributor gear.
To Adjust
Loosen three mounting screws that
secure the transmitter distributor to
its base. Position transmitter distribu­
tor to meet this requirement.
tighten the screws.
{Left Side View)
Re­
Page 33