Measuring Radius (X) And Length (Z); Completing The Measurement; Saving The Adapter; Figure 10: Control Device Smart Pro Iii - KELCH KENOVA set Line V224 Operating Instructions Manual

4.6

Measuring Radius (X) and Length (Z)

Figure 10: Control device Smart Pro III


Move the measuring carriage until the cutting edge appears in the display

Define the coordinates according to the control device

Read the values for X and Z on the display
4.7

Completing the Measurement


Remove the measuring carriage from the working area

Remove the tool from the tool holder

Switch off the main switch once you have finished measuring
4.8

Saving the Adapter

Calibrate the display instruments (=save the adapter) for the X and Z Axis using the
known measured variables of the setting mandrel

Measure X and Z of the setting mandrel

Save the values according to the manual for the control device in a suitable adapter
data record. This adapter applies to all measurements using the current tool holder.

Observe the manual for the control device
Seite 20
Kelch GmbH • Werkstraße 30 • D-71384 Weinstadt-Endersbach • Tel. (+49)7151 20522 0 • Fax (+49)7151 20522 11 • info@kelchgmbh.de
KENOVA set Line V224  Kelch GmbH 2013
4 Operation