Preparation For Measurement; Figure 7: Inserting The Tool Holder (Adapter Sleeve) (Accessories) Into The Spindle; Figure 8: Inserting The Tool (In Thes Example, A Setting Mandrel) - KELCH KENOVA set Line V224 Operating Instructions Manual

4.5

Preparation for Measurement


Remove the Camera from the tool area so that the work area is free!
Figure 7: Inserting the tool holder (adapter sleeve) (accessories) into the spindle

Make sure you use a tool holder that is suitable for the tool and that you have
selected the correct adapter for the control device (see "Saving the Adapter"). In the
spindle you can use various types of adapters, from simple reductions to adapters
for non-rotating tools of type VDI.
Figure 8: Inserting the tool (in thes example, a setting mandrel)
1 Tool
Possible damage to the setting device!
Metal chips, sand and other soiling can damage the setting drives for the Axis.
Do not remove the cover for the Axis!
Seite 18
Kelch GmbH • Werkstraße 30 • D-71384 Weinstadt-Endersbach • Tel. (+49)7151 20522 0 • Fax (+49)7151 20522 11 • info@kelchgmbh.de
2 Tool holder (adapter sleeve)
KENOVA set Line V224  Kelch GmbH 2013
4 Operation