Table of Contents
Advertisement
Poor color or no color
No stereo or SAP sound from a
known MTS broadcast
The remote control does not operate
The V-Chip PIN code does not work
Specifications
Television system
Channel coverage
Power source
Power consumption
Audio power
Speaker type
Video/Audio terminals
Dimensions
Weight
Supplied accessories
Optional TV stand
Design and specifications are subject to change without notice.
• The station may have broadcast difficulties. Try another channel.
• Adjust the TINT and/or COLOR in the PICTURE menu.
• If you change the direction of the TV while it is turned on, the
picture could suffer from color shading. If so, turn off the TV and
allow it to cool down for several hours before turning it on again.
• Make sure the MTS feature is set properly.
• Check if the TV/CABLE/VCR switch is properly set.
• There may be an obstruction between the remote control and the
remote control sensor.
• The remote control batteries may be dead. Replace the batteries.
• Change or reset your PIN code. (See page 16, "Selecting a PIN
code.")
NTSC standard
VHF: 2 through 13
UHF: 14 through 69
Cable TV: mid band (A-8 through A-1, A through 1)
super band (J through W)
hyper band (AA through ZZ, AAA, BBB)
ultra band (65 through 94, 100 through 125)
120 AC, 60 Hz
104 W
5 W + 5 W
2-3/8 x 4-3/4 inches (60 x 120 mm)
S-VIDEO INPUT
Y-INPUT: 1 V (p-p), 75 ohm, negative sync.
C-INPUT: 0.286 V (p-p) (burst signal), 75 ohm
VIDEO/AUDIO INPUT
VIDEO: 1 V (p-p), 75 ohm, negative sync.
AUDIO: 150 mV (rms) (30% modulation equivalent, 47 k ohm)
VIDEO/AUDIO OUTPUT
VIDEO: 1 V (p-p), 75 ohm, negative sync.
AUDIO: 150 mV (rms) (30% modulation equivalent, 47 k ohm)
Width: 34-9/16 inches (878 mm)
Height: 30-1/2 inches (774 mm)
Depth: 25-5/16 inches (642 mm)
158.0 lbs. (71.6 kg)
Remote control with two size "AA" batteries
ST3615
33
Advertisement
Table of Contents
