Table of Contents
Advertisement
Setting up your TV
After you've installed the batteries and programmed the remote
control, you need to set some preferences on the TV using the menu.
You can access the menu with the buttons on your TV or by using the
remote control.
• When you make a menu selection, your changes occur immediately.
You do not have to press MENU or EXIT to see your changes.
• After fifteen seconds, the menu screen will automatically disappear if
you do not make a selection. Your changes will still be saved.
• When you are finished programming the menus, press EXIT.
Changing the on-screen display language
You can choose from three different languages (English, French and
Spanish) for the on-screen displays. Adjustment menus and messages
will appear in the language of your choice.
To select a language:
1. Press MENU, then press
2. Press
or
to highlight LANGUAGE.
y
z
3. Press
or
to highlight your desired language.
x
•
Selecting the antenna input
You can connect to two different signal sources by choosing the
antenna input (ANT 1 or ANT 2).
To select the antenna input:
1. Press MENU, then use
2. Press
or
to highlight ANT 1/2.
y
z
3. Press
or
to highlight either ANT 1 or ANT 2, depending on
x
•
the antenna terminal you wish to use.
Using the TV/VIDEO button
You can monitor or change the signal source that is connected to the TV.
By pressing the TV/VIDEO button on your TV, you can select the
VIDEO 1, VIDEO 2, ColorStream, ANT 1 or ANT 2 mode. The signal
source you are currently connected to will be displayed in purple.
or
until the SET UP menu appears.
x
•
or
to highlight the SET UP menu.
x
•
TV/VIDEO
VOLUME T/S
MENU
TV/VIDEO
VOLUME
T
T/S/t/s
MENU
RECALL
1
4
7
100
MENU/
VOL
ENTER
TV
CABLE
VCR
12
CHANNEL s/t
CHANNEL
S
t
s
POWER
MUTE
2
3
5
6
8
9
CH RTN
0
ENT
CH
Menu/Enter
VOL
CH
Exit
EXIT
Advertisement
Table of Contents
