Trouble Shooting; Fault Table - Bosch DFT63CA.1 Series Instruction Manual

Removing metal grease filter
Pulling out the filter drawer
1.
Push the lock and push the metal grease filter
2.
backwards and pull downwards.
While doing this, place your other hand under the
metal grease filter.
To avoid causing damage, do not bend the
Note:
metal grease filters.
Take the metal grease filter out of the holder.
3.
Grease may accumulate in the bottom of the
Note:
metal grease filter. Hold the metal grease filter level
to prevent grease from dripping out.
After removing the metal grease filters, clean the
4.
inside of the appliance.
Clean the metal grease filters and let them dry
5.
before re-fitting them.
Installing the metal mesh grease filter
Insert the metal mesh grease filter.
1.
While doing this, place the other hand under the
metal mesh grease filter.
Fold the metal mesh grease filter upwards, locking it
2.
in place.
Changing the activated charcoal filter (only
in circulating-air mode)
In order to guarantee efficient odour filtration, the filter
must be serviced regularly.
The activated charcoal filters must be replaced at least
every 4 months.
Notes
The activated charcoal filters are not included in the
■
delivery. The activated charcoal filters can be
obtained from specialist retailers, from our after-
sales service or from the Online Shop.
The activated charcoal filters cannot be cleaned or
■
reactivated.
Remove the metal grease filters.
1.
Turn the old activated charcoal filter and pull away
2.
from the holder. ¨
Push the new activated charcoal filter onto the
3.
holder and turn. ©
Fit the metal grease filters.
4.

Trouble shooting

Malfunctions often have simple explanations. Please
read the following notes before calling the after-sales
service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.

Fault table

Problem Possible cause
The appliance The plug is not
does not work plugged into the
mains
Power cut
The fuse is faulty
The lighting does The LED lights
not work. are defective.
--------
en
Solution
Connect the appliance to the
power supply
Check whether other kitchen
appliances are working
Check in the fuse box to make
sure that the fuse for the appli-
ance is in working order
You can read about this in the
section entitled "Replacing
the LED lights".
9