Understanding The Power Return Feature; Appendix; Troubleshooting - Toshiba 27D47 Owner's Manual

Understanding the Power Return feature

If the power is cut off while you are viewing the TV and the power is resupplied, the Power Return feature will turn the TV on
automatically. If the power is going to be off for a long time or you are going to be away from the TV for a long time, unplug the
power cord from the wall outlet to prevent the TV from turning on in your absence.

Appendix

Troubleshooting

Before calling a service technician, please check the following table for a possible cause of the symptom and some solutions.
Symptom
Black box on screen
TV will not turn on
No picture, no sound
No sound, picture OK
Poor sound, picture OK
Poor picture, sound OK
Poor reception of broadcast channels
Cannot receive above channel 13
Unable to select a certain channel
Multiple images
Poor color or no color
No stereo or SAP sound from a known
MTS broadcast
The V-Chip password does not work
(U.S. V-Chip system only)
The remote control does not operate
Digital broadcasting screen problem
30K-01(B)_EN.indb 26 30K-01(B)_EN.indb 26
Solution
• Select OFF in the Closed Caption menu to turn off the Closed
Caption Text mode.
• If you connected a high-defi nition receiver, 480p progressive scan
DVD player, or other similar device to this TV, you must switch the
device's output to 480i interlaced mode fi rst. Failure to do this will
display the words "NO SIGNAL OR NOT SUPPORTED VIDEO
RESOLUTION" on a black screen.
• Make sure the power cord is plugged in, then press POWER.
• The remote control batteries may be dead. Replace the batteries.
• Check the antenna/cable connections.
• The sound may be muted. Press VOLUME.
• The station may have broadcast diffi culties. Try another channel.
• Set SAP to OFF in the OPTION menu.
• The station may have broadcast diffi culties. Try another channel.
• Set SAP to OFF in the OPTION menu.
• Check the antenna connections.
• The station may have broadcast diffi culties. Try another channel.
• Adjust the PICTURE menu.
• The station may have broadcast diffi culties. Try another channel.
• Check the antenna connections.
• Make sure the TV/CABLE feature in the SETUP menu is set to CABLE.
• The channel may be blocked by the V-Chip feature or erased with
the add/erase feature.
• The station may have broadcast diffi culties. Try another channel.
• Use a highly directional outdoor antenna.
• The station may have broadcast diffi culties. Try another channel.
• Adjust the TINT and/or COLOR in the PICTURE menu.
• If you change the direction of the TV while it is turned on, the
picture could suffer from color shading. If so, turn off the TV and
allow it to cool for several hours before turning it on again.
• Make sure the SAP feature (in the OPTION menu) is set to ON.
• Change or reset your password.
• Remove all obstructions between the remote control and the TV.
• The remote control batteries may be dead. Replace the batteries.
• Check the digital signal strength.
26
9/3/2550 16:41:02 9/3/2550 16:41:02