Timer Recording - Toshiba MW14F51 Owner's Manual

Timer recording

Timer recording can be programmed on-screen with the remote control.
The built-in timer allows automatic unattended recording of up to 8
programs within 1 month.
Timer recording
Preparation:
• Press TV/VCR to select the TV/VCR mode.
• Load a cassette tape with the erase prevention tab
intact.
• Check the time and date are correct
Example:
Program a timer recording for 23rd day, channel 125
(Cable TV), 7:00 - 9:30 PM (Tape speed : SLP).
1
Press MENU, then press
option.
2
Press or to select "TIMER REC SET", then
press .
3
Press or to select one of the program line,
then press ENTER.
4
Press or to select the date, then press
5T90101A [E]p39-42
.
or to select
TIMER REC SET
AUTO REPEAT OFF
/ / / / MENU
TIMER REC SET
AUTO REPEAT OFF
/ / / MENU
.
TIMER REC SET
DATE 2 3(THU)
START 8:3 0AM
END Ð Ð:Ð Ð
CH 0 1 2
SPEED S P
/ / / / MENU
41
5
Set the start time, end time, channel and tape
speed as in step 4.
Then press ENTER.
Notes:
• Press to move cursor backward
for correction.
• To record from external source set
the channel to "L".
6
To set the timer for another program, repeat
steps 3 to 5 to set another program.
7 Press TIMER REC. The TIMER REC indicator
will light. The Timer is programed, when the
programed time is reached, the recording is
automatically started.
To cancel timer recording, press the
TIMER REC
button again and TIMER REC
indicator will go out.
Notes:
• The VCR section cannot be used while the TIMER REC in-
dicator is lit. If you want to use the VCR operation, press
TIMER REC to deactivate the timer.
• When the clock is not set, you cannot select "TIMER REC".
In this case, set the clock (see pages 20~22).
• After a power failure or disconnection of the power plug,all
programmed recording setting and time display will be lost
upon resumption of power. In this case, reset the clock (see
pages 20~22) and reprogram any timer recordings.
• If you want to correct the digits while setting, press
until the item you want to correct, then press
correct the desired setting.
• If programming is performed without a tape in the unit, or
with a tape without an erase prevention tab, the Timer Re-
cording is not possible. If a tape without an erase prevention
tab is in the unit, the tape will be ejected.
3/8/05, 10:25 AM
TV/VCR
ENTER
/ / /
MENU
TIMER REC
TIMER REC SET
DATE 2 3(THU)
START 7:0 0PM
END 9:3 0PM
CH 125
SPEED S L P
/ / / / ENTER/MENU
2 3 T H 7 : 0 0 P M 9 : 3 0 P M 1 2 5 S L P
/ / ENTER/CANCEL/MENU
or
or to
41