Hudson 481 Series Owner's Manual page 32

HUDSON OWNER MANUAL
Figure 13
wheel (Fig- 13 ure 14). This can best be done after the car is jacked up, by reaching under
and raising up the loop at each end of the attaching rod until it is clear of its hook, as shown.
CHANGING THE WHEEL AND TIRE
Before raising the car, remove the hub cap with a screw driver and with the hub bolt
wrench (jack wrench) loosen the hub bolts one turn. Raise the car sufficiently to clear the
Your New Hudson is provided with spe-
cial jack lifting pads built into the frame at
the front and at the sides near the rear, which
assure maximum lifting efficiency and
safety and prevents the possibility of spring-
ing the bumpers.
Set the parking brake securely and block
the wheel opposite the one being changed to
prevent any movement of the car. Set the
jack base on a level and solid footing and
engage the lifting lug of the jack in the
socket of the frame pad, as shown. The
wheel bolt wrench is designed for use as a
handle to operate the jack.
When removing a rear wheel, it is neces-
sary to take off the wheel cover which is a
part of the rocker panel opposite the rear
27