Tv Operation; Tv Operations - Toshiba 19LV610U-T Owner's Manual

TV operation

TV operations

Basic operations
Power on
Press POWER on the unit or on the remote control.
The POWER indicator on the front of the unit changes to
green. It may take approximately 10 seconds for a
picture to appear on-screen.
POWER
POWER
TV signal selection
Select the TV signal type during the Auto Setup
27
operation. Go to page for more information.
Air – VHF/UHF channels
Cable – Cable TV channels
Volume adjustment
Press VOL + / – to adjust the volume level.
The volume status bar indicates the volume level. As
the volume level increases, so do the number of orange
bars. If the volume decreases, the number of orange
bars also decreases.
VOL
Volume mute
Press MUTE to switch off the sound. The TV/DVD's
sound will be turned off and "Mute" will appear on-screen.
Press MUTE again or VOL + / – to turn the sound on.
MUTE
Channel selection
Press the Direct Channel Selection buttons (0-9, –) or
/
CH to select a channel.
If you use Direct Channel Selection, there will be a
few seconds delay before the channel is displayed.
CH
JUMP
Note: If the selected channel is not broadcasting, the
sound will automatically be muted.
32
Analog channel selection
1-9 Press 1-9 as needed. For example, to select
channel 2, press 2, then press ENTER.
10-99 Press the 2 digits in order. For example, to
select channel 12, press 1, 2, then press
ENTER.
100-135 Press the 3 digits in order. For example, to
select channel 120, press 1, 2, 0, then press
ENTER.
Digital channel selection
Press the first 3 digits, then press –, followed by the
remaining number. For example, to select channel
015-001, press 0, 1, 5, –, 0, 0, 1.
• If the channel selected has only audio content, the
message "Audio only" will appear on-screen.
• If the digital channel selected has a weak signal, the
message "Digital channel signal strength is low." will
appear on-screen. The same program may be
available on either an analog or digital channel. You
may choose to switch format.
Note: There will be a few seconds delay before a digital
channel is displayed.
VHF / UHF / Cable Channels
Air
VHF
2-13
UHF STD/HRC/IRC
14-69 14-36
37-59
60-85
86-94
95-99
100-135
01
POWER
0–9, –
VOL +/-
/
CH
ENTER
Cable
VHF
2-13
(A) (W)
(AA) (WW)
(AAA) (ZZZ)
(86) (94)
(A-5) (A-1)
(100) (135)
(5A)