Table of Contents
Advertisement
Introduction
Precautions
Choosing a location for your LCD TV
•
Retractable pedestal stand and positioning the LCD TV
Observe the following safety precautions:
1. Ensure that the unpacking and transfer of the unit is carried out
by two or more people.
2. Put the LCD TV on a large level area in a recumbent posture.
3. Grab the pedestal stand and lift the display up. Confirm the pivot
is locked.
4. Place the TV on a sturdy, level surface that
can support the weight of the TV.
5. Be sure to secure the TV to a wall stud,
pillar, surface, or other immovable
structure. To secure the TV in this manner:
(1) attach a clip to an immovable structure,
then (2) pass a sturdy strap through the clip
and attach each end to the hooks located
at the back of the TV. Be sure to leave at least four inches
between the TV and the wall or similar structure for ventilation.
See item 22 on page 4 for additional details.
•
To fold the pedestal stand
1. Slide the lever on the back side of the pedestal stand to the left.
2. Lay the display down.
Slide the lever to the left
Rear side of the pedestal stand
IMPORTANT: Do not operate the LCD TV while the pedestal
stand is folded.
•
To display your LCD TV using a wall bracket
If you decide to wall mount your LCD TV, always use a UL listed
wall bracket appropriate for the size and weight of the LCD TV. Go
to page 2 for more information.
1. CAUTION: Two people are required for installation.
2. Unplug and remove any cables and/or other component connec-
tors from the rear of the TV.
3. Follow the instructions provided with your wall bracket. Before
proceeding, make sure the appropriate bracket(s) are attached
to the wall and the back of the TV as described in the instructions
provided with the wall bracket.
4. IMPORTANT: Always use the screws supplied or recommended
by the wall mount manufacturer.
5. After attaching the appropriate bracket(s) to the wall and the back
of the TV, remove the pedestal stand from the TV as described
below.
•
To remove the pedestal stand
1. Carefully lay the unit face down on a flat, cushioned surface such
as a quilt or blanket. Leave the stand protruding over the edge of
the surface.
IMPORTANT: Extreme care should always be used when
removing the pedestal stand to avoid damaging the LCD panel.
2. Remove the three screws shown in the diagram below. This will
allow removal of the pedestal stand.
3. Once you have removed the three screws holding the pedestal
stand in place, slide the pedestal stand away from the TV.
6
Important notes about your LCD TV
The following symptoms are technical limitations of LCD
technology and are not an indication of malfunction; therefore,
Toshiba is not responsible for perceived defects resulting from
these symptoms.
1. An afterimage (ghost) may appear on-screen if a fixed,
non-moving image is displayed for a long period of time. This
afterimage is not permanent and will disappear in a short period of
time.
2. The LCD panel contained in this TV is manufactured using an
extremely high level of precision technology; however, there may
be an occasional pixel (dot of light) that does not operate properly
(does not light, remains constantly lit, etc.). This is a structural
property of LCD technology. It is not a sign of malfunction, and is
not covered under your warranty. Such pixels are not visible when
the picture is viewed from a normal viewing distance.
Notes on handling the unit
•
Do not subject the LCD panel to physical shock, such as
dropping it. It may cause unit damage and malfunction.
•
When shipping the unit, the original shipping carton and packing
materials may come in handy. For full protection, repack the unit
as it was originally packed at the factory.
•
Do not use volatile liquids, such as insecticide, near the unit.
•
Do not leave rubber or plastic products in contact with the unit
for prolonged periods of time. Doing so will leave marks on the
finish.
•
The top and rear panels of the unit may become warm after a
long period of use. This is not a malfunction.
•
When the unit is not in use, always remove the disc and turn off
the power.
Notes on positioning the unit
•
•
•
Three screws
When you place this unit near a TV, radio, or VCR, the playback
picture may become poor and the sound may be distorted. In
this case, place the unit away from the TV, radio, or VCR.
To avoid damage to this product, never place or store the unit in
direct sunlight; hot, humid areas; or areas subject to excessive
dust or vibration.
The socket outlet must be installed near the unit and is easily
accessible.
Hide quick links:
Advertisement
Table of Contents
