Figure 1; Introduction - Toro Recycler 20958 Operator's Manual

Replacement parts are available from an Authorized Service Dealer or at www.shoptoro.com.

Introduction

This rotary-blade, walk-behind lawn mower is intended to
be used by residential homeowners. It is designed primarily
for cutting grass on well-maintained lawns on residential
properties. It is not designed for cutting brush or for
agricultural uses.
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready.

Figure 1

model and serial numbers on the product.
1. Model and serial number plate
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
CV
55cm Recycler
Model No. 20958—Serial No. 316000001 and Up
identifies the location of the
Figure 1
Register at www.Toro.com.
® Lawn Mower
This manual identifies potential hazards and has safety
messages identified by the safety-alert symbol
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety-alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
Important: If you are using this machine above 1500 m
(5,000 ft) for a continuous period, ensure that the High
Altitude Kit has been installed so that the engine meets
CARB/EPA emission regulations. The High Altitude
Kit increases engine performance while preventing
spark-plug fouling, hard starting, and increased
emissions. Once you have installed the kit, attach
the high-altitude label next to the serial decal on the
machine. Contact any Authorized Toro Service Dealer
to obtain the proper High Altitude Kit and high-altitude
label for your machine. To locate a dealer convenient to
you, access our website at www.Toro.com or contact our
Toro Customer Care Department at the number(s) listed
in your Emission Control Warranty Statement.
Remove the kit from the engine and restore the engine
to its original factory configuration when running the
engine under 1500 m (5,000 ft). Do not operate an engine
g036584
that has been converted for high-altitude use at lower
altitudes; otherwise, you could overheat and damage
the engine.
If you are unsure whether or not your machine has been
converted for high-altitude use, look for the following
label (Figure
Form No. 3400-880 Rev A
Operator's Manual
Figure 2
3).
All Rights Reserved *3400-880* A
Original Instructions (EN)
Printed in the USA
(Figure 2),
g000502