Sound And Vibration - EINHELL BT-LC 500 Original Operating Instructions

Firewood drag saw

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Anleitung_BT_LC_500_SPK7__ 22.08.12 10:14 Seite 16

measurements and cleaning jobs only when the

motor is switched off. Pull the power plug!

Before switching on, make sure that all keys and

wrenches have been removed from the tool.

Switch off the motor and pull the power plug

before you leave the workplace.

Refit all guards and safety devices immediately

after you have completed any repairs or

maintenance work.

Be sure to observe the safety information and

operating and maintenance instructions issued

by the manufacturer, as well as the dimensions

listed in the Technical Data.

It is imperative to observe the accident

prevention regulations in force in your area as

well as all other generally recognized rules of

safety.

Note the information published by your

professional associations (VBG 7j).

The circular saw has to be connected to a 230 V

socket with a 16 A fuse.

Do not use the cable for purposes for which it is

not designed.

Make sure you stand squarely and keep your

balance at all times.

Check the tool for damage.

Each time before re-using the tool, carefully

check that the guards or any slightly damaged

parts are working as intended.

Check that the moving parts are in good working

order, that they do not jam, and that no parts are

damaged. Make sure that all parts are fitted

correctly and that all other operating conditions

are properly fulfilled.

Unless otherwise stated in the operating

instructions, damaged safety devices and parts

must be repaired or replaced by an authorized

service center.

Have damaged switches replaced by a customer

service workshop.

This electric tool complies with the pertinent

safety regulations. Repairs are to be carried out

only by a qualified electrician using original

replacement parts or the user may suffer an

accident.

If necessary, wear suitable personal protection

equipment. This could consist of:

- Ear plugs to prevent the risk of damaging your

hearing;

- A breathing mask to avoid the risk of inhaling

hazardous dust.

- Always wear gloves when handling saw blades

and rough materials. Whenever practicable, saw

blades must be carried in a container.

The operator must be informed about the

conditions that influence the generation of noise

(for example saw blades designed to reduce

noise emissions, caring for blades and the

machine).

Faults on the machine or its guards, safety

devices and blade must be reported to the

person in charge as soon as they are

discovered.

Use only the transport devices to move the

machine. Never use the guards for handling and

moving the machine.

All operators must receive proper training in the

use, adjustment and operation of the machine.

Do not saw any materials that contain foreign

bodies such as wires, cables or ties.

Only use sharp saw blades.

Stack the workpieces you want to work on as well

as the finished workpieces near your working

position.

Note the maximum speed which is printed on the

saw blades.

Make sure that the flanges used are suitable for

the intended purpose as specified by the

manufacturer.

Adopt the safe working practices for cleaning and

maintenance and for the regular removal of chips

and dust in order to prevent a risk of fire.

The saw is allowed to be used only when all the

safety devices are fitted and their proper

operation has been checked.

Throughout the machine's anticipated service life,

make sure that the machine and its components

cannot topple, fall over or move out of control

during transport, assembly, disassembly,

disabling and scrapping.