Advertisement
Step 3 Attach the support assembly
Loosen the set screws (2) in the support rod cou-
pler located on the top center of the motor hous-
ing (see figure 5) until the inside channel is clear.
Remove and save the safety pin from the cou-
pler.
Place the ceiling canopy face down (small end)
over the support rod coupler on the motor hous-
ing.
Slide canopy onto support rod.
Feed the electrical wires from the fan housing
through the support rod.
Thread the support rod into the support rod cou-
pler until the safety screw can be inserted
through the hole in both the rod and coupler.
Insert the safety screw through the hole in the
support rod coupler and support rod then tighten
firmly.
Insert the set screw in the coupler and tighten
firmly.
Step 4 Hanging the Fan Body
Notice the half ball on the end of the support rod is
grooved down one side. This Keyway fits over the
small keyway pin on the inside of the mounting brack-
et and keeps the ceiling fan from spinning on the
mounting bracket.
Lift the fan and place the half ball in the center of the
mounting bracket with the keyway pin inserted into the
keyway on the ball. Turn the fan left and right slightly
to make sure it is seated on the bracket with the keyway
pin in the keyway (see figure 6).
Trim the lead wires, leaving about six inches of each
wire extending from the support rod.
Canopy
Support Rod Coupler
Set Screw
Fig. 5
Receiver
Unit
6
Set Screw
Safety Screw
Mounting Bracket
Support Rod
Fig. 6
Advertisement
