Casio fx9750GII Getting Started page 74

CONNECTION TO OTHER DEVICES
A Quick Guide to Using the EA-100 Data logger - Manual Set Up
Step 1: Be sure to connect an Auto-ID probe to CH1, CH2, CH3 or SONIC channel.
Step 2: Switch the Data Analyser to Communications mode by pressing the [MODE]
key ("Done" appears on the screen).
Setting Time Interval, Number of Samples and Time Type
Time Interval Setting
Step 1: To access, press [SHIFT] [MODE].
Step 2: Press [Data Log] to scroll through available settings.
Settings are:
Milliseconds: 10, 20, 50, 100, 200, 500
Seconds: 1, 2, 5, 10, 20, 30, 60
Press [Trigger] to set the Time Interval and to advance to the next setting
Time Interval Setting
Step 1: Press [Data Log] to scroll through available settings:
0, time recording off;
1, absolute time recording;
2, relative time recording
Step 2: Press [Trigger] to set the Time Setting.
Data Collection & Transfer
Data Collection
"Ready" appears on the display.
Step 1: Press [Trigger] for the Data Analyser to begin collecting data.
Step 2: "Done" appears when data collection is complete.
Data Transfer to a Graphics Calculator
Connect the calculator to the Data Analyser (Press plugs in firmly).
Step 1: Run the program "MANUAL" in the Program Mode of the calculator. Data will automatically be transferred to
the calculator and a graph of this data displayed.
Data Analyser - Multimeter Mode
In this mode, the Data Analyser can perform a variety of different sampling operations using a selection of units. This
mode can be used to sample voltage, resistance, current, period, frequency and distance. Sampling can be performed
using CH1, CH2, CH3, SONIC or DIG IN.
To enter Multimeter Mode
Press [MODE] key. MULTIMETER indicator is displayed.
To select channel
Press [CH-View] key continuously until desired channel is displayed.