Advertisement
Advertisement
Table of Contents
Related Manuals for Spotsee Log-IC
Summary of Contents for Spotsee Log-IC
- Page 1 Log-IC User Manual...
- Page 2 Turning a Recorder On/Off..............................3 Checking the Status of a Tag ............................. 4 Log-IC USB ..................................5 Proper Placement of LOG-IC ............................. 5 Optional Log-IC Desktop Readers ..................6 This document is written and published by SpotSee All rights reserved.
- Page 3 ON/OFF Button In the following sections, the following symbols represent a solid LED light: SOLID RED SOLID GREEN The following symbols represent a blinking LED light: BLINKING RED BLINKING GREEN This document is written and published by SpotSee All rights reserved.
- Page 4 There are several options for turning on/off Log-IC. The instructions below describe using the ON/ / OFF Button. In order to use the ON/OFF button on the front of the tag, the tag must be placed in standby mode and configured using the Log-IC Interface Application.
- Page 5 (HI) excursion. SOLID SOLID BLINKING SOLID The tag is recording and there has The tag is off, delayed/soaking or been a high and low excursion. in standby. This document is written and published by SpotSee All rights reserved.
- Page 6 USER MANUAL LOG-IC USB Log-IC tags communicate to the Log-IC Interface Application via USB port. To access the USB, remove the cover as shown and plug into an available PC USB port. When connected, the tag LEDs will blink, confirming a successful connection.
- Page 7 PC via a USB cable. Once the desktop reader is connected to a PC and the Log-IC Interface Application is open, hold the tag within two inches of the DTR. Be sure that the desktop reader is not near or on any metal objects (file cabinets, etc.) as this will cause interference with the RF signal.
Need help?
Do you have a question about the Log-IC and is the answer not in the manual?
Questions and answers