Using Standby/Sleep/Hibernation Modes With The Dynadock - Toshiba PA3927U-1PRP dynadock U3.0 User Manual

To charge a device when the dynadock™ is disconnected or the
connected computer is off:
NOTE
1
Make sure the dynadock's AC adaptor is connected to an
electrical outlet.
2 Connect the USB device you want to charge to the USB port on
the front of the dynadock™.
NOTE
To stop charging the USB device, disconnect the device from the
dynadock™.
Using standby/sleep/hibernation modes with the
dynadock™
When your docked computer enters standby/sleep/hibernation
mode, devices connected to the dynadock™ will not function until
the computer returns to an active state. For example, if you are
using the Ethernet port for high-speed network access, network
access will not be available until the computer resumes from
standby/sleep/hibernation.
In addition, please keep in mind the following important
information regarding the affect of standby/sleep/hibernation mode
on external displays connected to the dynadock™:
❖
The external display connected to the dynadock™ will go
blank if the computer enters standby/sleep/hibernation mode.
❖
In Mirror mode, the external display retains the settings it had
previously when the computer resumes from standby/sleep/
hibernation.
Using the dynadock™ and Adjusting Settings
Using the "USB Sleep and Charge" function to charge external
devices may take longer than charging the devices with their own
chargers.
When there is a current overflow of the external USB device
connected to the compatible port, USB bus power (DC 5V) supply
may be stopped for safety reasons.
35