Connecting; Disconnecting - Toshiba PA3314U User Manual

User's Manual

Connecting

1. Make sure the connectors are properly aligned and plug the i.LINK (IEEE1394)
cable into the computer.
2. Plug the other end of the cable into the device.
Note the following when you use i.LINK:
You may need to install drivers for your i.LINK devices.
Not all i.LINK devices have been tested, therefore, compatibility with all i.LINK
devices cannot be guaranteed.
Use S100, S200 or S400 cables no longer than three meters.
Some devices might not support standby or automatic-off functions.
Do not connect or disconnect an i.LINK device while it is using an application
or when the computer is automatically shutting it down to save power. Data
might be destroyed.

Disconnecting

1. Click the Unplug or Eject hardware icon on the Task Bar.
2. Select i.LINK (IEEE1394).
3. When You can disconnect your i.LINK device appears, click
OK.
4. Disconnect the cable from the computer, and then from the i.LINK device.
NOTE: Please also refer to your i.LINK device's documentation.
4-6
Figure 4-4 Connecting the i.LINK cable