Garland MULE 141 E Instruction Manual page 26

English
5. START UP INSTRUCTIONS
5.1. LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Engine
• Tube connecting screw
• Connecting wing nut
• Instruction manual
5.2. MOUNTING THE MACHINE
1. Introduce the superior tube into the inferior tube
and connect using the screw and wing nut
provided.
2. Place the handle in the most comfortable working
position.
5.3. CHECKING POINTS PRIOR TO WORKING
The current and tension supplied must coincide
with those in the characteristics label. Prior
to starting work check that the machine works
adequately and all security measures work.
Check the machine and look for any loose pieces
(screws, nuts, housing etc) and for any damages.
Tighten, repair or replace those pieces that you have
found to be in a bad state. Ensure that there are no
leakages. Do not use the machine if damaged or not
well regulated.
5.3.1. FIJACIÓN DEL PROLONGADOR DE CABLE
Only use cable extensions that are homologated
for outdoor use. The cable section must be at least
1.5mm and the cable extension should never be
longer than 25m and must be completely unrolled
before starting to work.
Fix the extension of the
tiller by inserting cable in
the hook on the handle and
plug onto the machine.
5.4. START UP AND STOPPAGE
Start up the machine:
Press the security button (1)
and without letting go, press
the On/Off switch (2).
Stoppage of the machine:
Let go of the On/Off switch (2).
5.5. OVERLOAD PROTECTION
This tiller has a security switch that will disconnect
the machine in the fllowing circumstances:
• If too much material accumulates on the blades.
• If the material being worked on is too resistant for
the engine capacity.
• If the machine detects a high level of resistance on
the blades.
If you detect that the machine does not start when the
switch is on the On position, the probable cause will
be that the security switch is activated. In this case
disconnect the machine from the mains, place the
switch on the Off position, check that the blades are
clean and have no elements that impede the blades
from turning and wait 15 minutes before starting the
machine again.
26/88
1
2