Table of Contents
Advertisement
OPERATING FIREPLACE
Continued
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be
purchased separately (see Accessories, pages 40
and 41). Follow instructions included with the
remote control.
NOTICE: You must light the pi-
lot before using the hand-held
remote control unit. See Light-
ing Instructions on page 23.
1. After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust flame adjustment knob any-
where between HI and LO. Slide the selec-
tor switch to the REMOTE position (see
Figure 42). Note: The burner may light if
hand-held remote was on when selector
switch was last turned off. You can now turn
the burner on and off with the hand-held
remote control unit.
IMPORTANT: Do not leave the selector
switch in the REMOTE or ON position when
the pilot is not lit. This will drain the battery.
Flame
Adjustment Knob
REMOTE
OFF
ON
Selector Switch in Remote
Position (Optional Remote Control)
Figure 42 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
ON/OFF SERIES (MODEL [C]GHRCB)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 43).
press both buttons on hand-held re-
TO LOCK
mote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when any
button is pressed.
press both buttons together on
TO UNLOCK
hand-held remote control until the light stops
flashing. The hand-held remote is now un-
locked.
111244-01C
Figure 43 - On/Off Hand-Held Remote
THERMOSTAT SERIES (MODEL
[C]GHRCTB)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 44, page 26).
To select Fahrenheit/Centigrade mode display,
carefully press the ˚C/˚F mode button with the
end of a paper clip or similar blunt object.
Digital
Display
Shows
Temperature
and Settings
Turns
Burners On
or Off
Decreases
Room
Control
Temperature
Knob
in AUTO
Mode
OUT
IN
LO
Figure 44 - Thermostat Hand-Held
Remote Control Unit ([C]GHRCTB)
Manual Mode
1. Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2. Press the MANU button to turn on the fire-
place.
3. Press the POWER and LOCK buttons to-
gether to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press-
ing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons to-
gether to turn off the fireplace
www.desatech.com
Control Button
Turns Burners
On and Off
Control Unit (GHRCB)
Locks System to
Prevent Accidental
Ignition
Turns Hand-
Held Remote
On or Off
and Allows
You to
Choose the
Manual
Setting
Selects Auto
Setting
Increases
Room
Temperature
in AUTO
Mode
25
Advertisement
Table of Contents
