Desa HEARTH CDCFTN Owner's Operation And Installation Manual page 15

Unvented (vent-free) gas compact classic dual burner fireplace
Table of Contents

Advertisement

INSTALLATION
Continued
For Built-In Installation
WARNING: A licensed elec-
trician must connect the wiring
harness to electrical supply fol-
lowing all local codes. Electri-
cian must provide a clamp on
the box cover to secure the wir-
ing. Wiring should be routed
through the bushing in the hole
on the outer casing of fireplace.
1. Install snap bushing from blower kit into one
hole on rear of remote/blower bracket (see
Figure 17). The other hole is for a strain relief
clamp (not supplied) to secure incoming elec-
trical supply.
2. Follow steps 2 through 6 in Installing Blower
Accessory, page 14.
3. A licensed electrician must follow the wiring
diagram to connect incoming electrical sup-
ply to fan kit wiring harness (see Figure 18).
4. Plug power cord to outlet receptacle (not pro-
vided) as shown in Figure 17. Wind extra cable
of power cord and tie up with plastic wire strap
(see Figure 17). Set cable bundle between the
remote/blower bracket and outer casing, away
from the burner.
Blower Bracket
Assembly
Screw
Power Cord
Switch
3
2
1
Switch
Plate
Plastic Wire Strap Wire Harness
111244-01C
Wire Harness
Outlet Receptacle
(not included)
Lower Louver Door
Figure 17 - Installing Blower Bracket Assembly
www.desatech.com
5. Test to make sure blower is working properly.
6. Reinstall upper louver beginning with bottom
screws (see Figure 11, page 12) and close
lower louver.
Extension Cord
Use extension cord if needed. The cord must have a
three-prong, grounding plug and a three-hole recep-
tacle. Make sure cord is in good shape. It must be
heavy enough to carry the current needed. An under-
sized cord will cause a drop in line voltage. This
will result in loss of power and overheating. Use a
No. 16 AWG cord for lengths less than 50 feet.
110/115
V.A.C.
Black
White
Green
Figure 18 - Wiring Diagram For Blower
Accessory Built-In Installation
Fan Switch
(Auto/Off/On)
Auto
1
2
Off
3
Thermostat
Blue
Switch
On
(N.O.)
Blue
Red
Red
White
Green
Clamp Connector
(not included)
Remote/ Blower
Bracket
Blower
Motor
15

Advertisement

Table of Contents
loading

Table of Contents