INSTALLATION
Continued
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
Remote-Ready Models Only
([C]GHRCB Series & [C]GHRCTB
Series)
Installing Receiver
1. Disconnect wires from the control valve (see
Figure 26) .
2. Locate the battery clip mounted on the back
of the receiver (see Figure 27).
3. Slide 9-volt battery (not included) through the
clip.
4. Attach the terminal wires to the battery (see
Figure 27).
5. Connect wires from remote receiver to con-
trol valve as shown in Figure 28.
6. Install remote receiver unit onto remote/
blower bracket using screws provided (see
Figure 28).
Figure 26 - Disconnecting Wires From
Control Valve
Receiver
9-Volt
Battery
Figure 27 - Attaching Battery to Receiver
White Wire to
TH Terminal on
Control Valve
Remote
Receiver
Figure 28 - Installing Remote Receiver
111244-01C
Terminal
Wires
Battery Clip
Red Wire to TPTH
Terminal on
Control Valve
www.desatech.com
Installing 9-Volt Battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote con-
trol unit.
2. Attach terminal wires to the battery (not in-
cluded). Place battery into the battery housing.
3. Replace battery cover onto remote control unit.
Battery Cover
Terminal
Wires
9-Volt
Battery
Figure 29 - Installing Battery in Hand-
Held Remote Control Unit (GHRCB and
CGHRCB Series)
Terminal Wires
9-Volt
Battery
Battery
Housing
Figure 30 - Installing Battery in Hand-
Held Remote Control Unit (GHRCTB and
CGHRCTB Series)
OPTIONAL WALL MOUNTED
THERMOSTAT - GWMT1
(Remote-Ready Models Only)
WARNING: Read and follow
installation instructions. Instal-
lation should be done by a quali-
fied installer familiar with low-
voltage wiring procedures.
WARNING: Do not connect
this thermostat to any electrical
source! Electrical shock and/or
fire hazard will occur.
1. Remove jumper wire from control valve (see
Figure 26).
Remote
Control Unit
Battery
Housing
Remote Control Unit
Battery
Cover
19