Table of Contents
Advertisement
68
Getting Started
Using external display devices
Configuring virtual buttons
The virtual buttons at the top of the Dual Mode Pad are pre-
configured for the Email, ConfigFree, and Print functions. You can
assign different functions to these buttons if you wish.
The virtual buttons on the bottom of the Dual Mode Pad (buttons 4,
5, and 6 in the Properties for Synaptics LuxPad window) are
unassigned by default. In order to use one of these buttons, you
must first configure that button so that it is associated with a
function.
To configure a virtual button:
1
Perform steps 1-5 in
2
Select the virtual button you wish to configure.
3
Select the desired options, and then click OK.
4
Click OK.
5
Click OK to close the Mouse Properties window.
Using external display devices
Your computer comes with a built-in LCD display, but you can also
connect the following types of external display devices to the video
ports described below:
❖
An HDMI-compatible television or VCR/DVD player via the
HDMI Out port*
❖
A standard television, projector, or VCR/DVD player via the S-
video Out port
❖
An external monitor or projector via the RGB (monitor) Out
port
(Sample Illustration) Back of system
*Available on certain models
You cannot connect both the S-video Out port and the HDMI Out
port to the same device at the same time.
The system display default is set at the factory to S-video Out.
"Enabling Dual Mode" on page
S-video Out port*
RGB (Monitor Out) port
67.
HDMI Out port*
*Available on certain models
Advertisement
Table of Contents
