Maintenance; Recommended Maintenance Schedule(S); Greasing The Brush Cutter - Toro TXL 2000 Operator's Manual

Maintenance

Determine the left and right sides of the machine from the normal operating position.
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the switch before you perform any maintenance.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
Before each use or daily
Every 50 hours

Greasing the Brush Cutter

Service Interval: Before each use or daily
Grease type: General-purpose grease
1. Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2. Shut off the engine and remove the key.
3. Clean the grease fittings with a rag.
4. Grease the 2 rear roller bearings and 2 front
caster fittings.
Maintenance Procedure
• Grease the machine.
• Check the planetary fluid level.
• Check the blade carrier bolts. Apply thread-locking compound to loose bolts and
torque to 183 to 223 N∙m (135 to 165 ft-lb).
• Inspect the blades.
• Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting
supports, wear, weather, and chemical deterioration.
• Remove debris from the attachment.
• Pressure wash the top and underside of the cutting deck.
Figure 6
g268729
8