Page 1
Manufacturer: ALINCO, INC. PMR446 FM TRANSCEIVER Yodoyabashi Dai-bldg 13F 4-4-9 Koraibashi, Chuo-ku, Osaka 541-0043 Japan DJ-PN446 Phone: +81-6-7636-2362 Fax: +81-6-6208-3802 http://www.alinco.com E-mail:export@alinco.co.jp Electrical and electronic equipment and batteries should be recycled at a facility capable of handling these items. Copyright Alinco, Inc.
Page 2
The utility software may be available to distributors/dealers only. Programming cable is optional. passengers or drivers against lightning as well. Therefore, Alinco will not take responsibility for any The manufacturer will not release the software to unauthorized party so please contact your dealer for danger associated with using its handheld radios outdoor or inside the car during lightning.
Page 3
Features ● Frequency: PMR446 (99ch) To prevent any hazard during operation of Alinco’s radio product, in this manual and on the product you ● Power: 0.5W may find symbols shown below. Please read and understand the meanings of these symbols before ●...
Page 4
Be sure to reduce the audio output level to minimum before using an optional earphone. Excessive audio may damage hearing. Use of this product may be prohibited or illegal outside of your country. Be informed in advance when you travel. Unauthorized modification or repair may result in electric shock, fire and/or malfunction and voids warranty.
Page 5
Do not place in a humid, dusty or insufficiently ventilated place. It may result in electric shock, fire and/or malfunction. In case of the following situation (s), please turn off the product, switch off the source of power, then remove or Do not place in an unstable or vibrating position.
BATTERY INFORMATION BATTERY INFORMATION Charging Operation Notice for Charging Battery ▲ The ambient temperature should be between +5℃ to +40℃ (+41℉ to +104℉) while charging. The battery is not fully charged at the factory, please charge it before use. The battery life is over when its operating time decreases even though it is fully and correctly charged. Charging outside this range may not fully charge the battery.
BATTERY INFORMATION INSTALLING / REMOVING MICROPHONE (Battery in this chapter refers to the one inside) Caution ● Risk of explosion, generation of heat or leak of chemicals inside if the battery is replaced by an The microphone jack is located at the incorrect type or reverse polarity.
Pressing and holding ▲/▼ keys while selecting channels will continuously change numbers. Please refer to P. 17 for DJ-PN446's default channel setting. Leave it for 5 seconds, or press either PTT or P- key to set the selected channel.
● In the menu to edit, press ▲/▼keys to select a parameter of your preference. matching signal can open the squelch and hear the audio. DJ-PN446 is programmed with CTCSS and ● Press P-key to set and continue to edit, or press PTT to complete the setting and exit.
SET MODE SET MODE 3) VOX ON/OFF BT [BГ]: 5) End beep [Eb]: VOX allows hands-free operation. It transmits when the microphone detects certain level of audio This function adds a beep sound at every end of transmission to inform the transmission is completed. (voice), and returns to receive when the audio is gone.
RESET TROUBLE SHOOTING Turn off the radio. Press P, ▼ and PTT keys all together for 2seconds. Problem Corrective action RT and the version is displayed and turns on with default setting. A. The battery may be exhausting. Recharge or replace the battery. No power B.
TROUBLE SHOOTNG DEFAULT CHANNEL SETTING Channel CTCSS / Channel CTCSS / The receiving sound level is Frequency(MHz) Frequency(MHz) Consult with local dealers for inspection. Number DCS Tone Number DCS Tone low or intermitted. 446.00625 94.8 446.04375 D132N Out of communication range or obstruct by buildings etc. Receiving signal is intermittent.