Battery Information (Battery In This Chapter Refers To The One Inside); Installing / Removing Microphone - Alinco DJ-PN446 Instruction Manual

BATTERY INFORMATION
(Battery in this chapter refers to the one inside)
Caution
● Risk of explosion, generation of heat or leak of chemicals inside if the battery is replaced by an
incorrect type or reverse polarity.
● Charging should be conducted in a temperature range of +5ºC to +40ºC (+41ºF to +104ºF).
● Don't modify, dismantle, incinerate or immerse the battery in the water as this can be dangerous.
● Never short-circuit the battery , as this can cause damage to the equipment or lead to heating of
the battery which may cause burns.
● Unnecessary prolonged charging (overcharging) can deteriorate battery performance.
● Battery is a consuming part. When its operating time becomes considerably short after a normal
charge, please consider that the battery is exhausted. Please consult your dealer.
● The battery is recyclable. Check with your local waste officials for details on recycling options or
proper disposal in your area.
● Use specified genuine chargers only to charge battery. Use of other chargers may cause damage
to products, you and your property.
● The battery inside discharges even when turned off due to standby current.
Supplementary charge it every once in a while. Over discharged battery won't accept the charge.
4

INSTALLING / REMOVING MICROPHONE

The microphone jack is located at the
bottom side of the radio.
Connect EME-82 as shown to the jack
and place the cable upward.
Note: Use of the earphone microphone
is optional.
NOTE:
● Use of third party accessory may result in damage to this product. It will void our warranty for repair.
● Never twist, bend, lean, curl the cable. EME-82 is not repairable.
● Both the radio and EME-82 are not water-resistant. Be mindful to water and dust as the jack is not
covered for protection.
5