Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus
one turn of a wrench only! This will temporarily hold the
locknut on the bolt while helping alignment of all parts!
After all parts are assembled together, all nut and bolt
combinations must be completely tightened.
STEP 1
NOTE: When selecting a tree to install the
treestand in, never use a treestand on a dead,
leaning, diseased or loose barked tree, or a utility
pole. Always avoid electrical power lines.
1.
Take two side rails (10) and assemble them to the
outer edge of the tree blade (11) using four 1/4 X
2-1/2 IN bolts (23), and four 1/4-20 nuts (24).
SEE FIGURE 1.
STEP 2
2.
Begin the assembly of the seat by sliding one seat
rail (6) through each pocket on the sides of the
sewn seat (13). SEE FIGURE 2A.
Slide the loop ends of the seat strap onto each seat
side rail (10). SEE FIGURE 2B.
FIGURE 1
FIGURE
2A
FIGURE
2B
Instruction Manual : 15' LADDER STAND
10
6
11
24
23
13
10
11
Advertisement
Table of Contents
