Table of Contents
Advertisement
M37750/51--Running user program
Initializing the
Emulator
# Limited initialization completed
2-8 Getting Started
Using the Emulation Status Command (es) for Description
of Current Prompt
When using the emulator, you will notice that the prompt changes after
entering certain commands. If you are not familiar with a new prompt
and would like information about that prompt only, enter the es
(emulation status) command for more information about the current
status.
U>es
If you plan to follow this tutorial by entering commands on your
emulator as shown in this chapter, verify that no one else is using the
emulator. To initialize the emulator, enter the following command:
R>init
The init command with no options causes a limited initialization, also
known as a warm start initialization. Warm start initialization does not
affect system configuration. However, the init command will reset
emulator and analyzer configurations. The init command:
Resets the memory map.
Resets the emulator configuration items.
Resets the break conditions.
Clears software breakpoints.
The init command does not:
Clear any macros.
Clear any emulation memory locations; mapper terms are
deleted, but if you respecify the same mapper terms, you will
find that the emulation memory contents are the same.
Advertisement
Table of Contents
