Displaying And Maintaining Dldp; Dldp Configuration Example - H3C S5500-EI Series Operation Manual

Operation Manual – DLDP
H3C S5500-EI Series Ethernet Switches
To do...
Enter system view
Enter
Ethernet
port
view/port
group
view
Reset DLDP state

1.3 Displaying and Maintaining DLDP

To do...
Display the DLDP
configuration of a port
Display the statistics
on DLDP packets
passing through a port
Clear the statistics on
DLDP packets
passing through a port

1.4 DLDP Configuration Example

1.4.1 DLDP Configuration Example
I. Network requirements
Device A and Device B are connected through two fiber pairs, in which two fibers
are cross-connected, as shown in
It is desired that the unidirectional links can be disconnected on being detected;
and the ports shut down by DLDP can be restored after the fiber connections are
corrected.
Use the command...
system-view
Enter
interface interface-type
Ethernet
interface-number
port view
Enter
port-group { aggregation
port
agg-id | manual
group
port-group-name }
view
dldp reset
Use the command...
display dldp [ interface-type
interface-number ]
display dldp statistics
[ interface-type
interface-number ]
reset dldp statistics
[ interface-type
interface-number ]
Figure 1-4.
1-15
Chapter 1 DLDP Configuration
Remarks
—
Either is required.
The configuration
performed in Ethernet port
view applies to the current
port only; the configuration
performed in port group
view applies to all the ports
in the port group.
Required
Remarks
Available in any view
Available in any view
Available in user view