Setting The Test Tone; Setting The Drc (Dynamic Range Compression) - Samsung HT-HDP40 Instruction Manual

Setting the Test Tone

Use the Test Tone feature to check the speaker connections.
In Stop or no
1 2
disc mode,
press MENU
button.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
Alternate method: press the TEST TONE button on the remote.
Press TEST TONE button.
•
Test tone will be produced as follows:
When playing a DVD or CD, this will work only in Stop mode.
•
Use this function to check that each speaker is correctly
connected and that there is no problem.
•
When there is no input signal from the HDMI IN function, the
Test Tone will not work.
To end the test tone,
press TEST TONE button again.
55
Press Cursor Press Cursor
3
button to move to to move to 'TEST
'Audio' and then TONE' and then press
press ENTER button. ENTER button.
•
The test tone will be sent to L
R SR SL SW in order.
If the ENTER button is pressed again
at this time, the test tone will stop.
L: Front Speaker (L) C: Center Speaker SW: Subwoofer
R: Front Speaker (R) SL: Rear Speaker (L) SR: Rear Speaker (R)
Multi-Channel Pro Logic Mode
Start
Setting the DRC
You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.
button
C
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
(Dynamic Range Compression)
Press Cursor
1 2
In Stop or no disc
button to move to
mode, press
'Audio' and then
MENU button.
press ENTER
button.
Press Cursor
3 4
Press Cursor
button to move to
'DRC' and then
the 'DRC'.
press ENTER
button.
•
When the Cursor
the effect is greater, and when the
Cursor button is pressed, the effect is
smaller.
ENG
, to adjust
button is pressed,
56